Outback Power Systems HUB10 Manual de usuario descargar pdf (Pagina 9)

Common Wiring Con gurations

Single FX Series Inverter/Charger and OutBack Controller

• Plug the FX into Port 1 of the HUB.

• The Charge Controller and any future OutBack devices can be plugged into any

remaining non-MATE ports.

Multiple OutBack Charge Controllers Only

• Plug one Charge Controller into Port 1 and the others into any remaining ports.

• A FLEXnet DC can be plugged into a remaining port as well.

Series/Parallel Phase-Stacked FX Series Inverter/Chargers

• The FX designated as the Master must be plugged into Port 1.

• Plug additional FXs in remaining ports in numerical order followed by any OutBack Charge

Controllers.

• Some PC monitoring software requires that 120/240 VAC series-stacked or series

parallel stacked FX Systems be wired with all LEG 1 (L1) phased FXs as odd numbered

Ports and all LEG 2 (L2) phased FXs as even numbered Ports. This arrangement

also makes programming the FX Slave power save level settings more intuitive.

Three- Phase FX Series Inverter/Charger Stacking

• Connect the Master FX (Phase A) to Port 1.

• Connect the phase B Slave to Port 2.

• Connect the phase C Slave to Port 3.

• The HUB jumper must be in the three phase position as described in the three- phase

stacking section (please see next page).

• Other OutBack devices can be plugged into any unused ports. Currently, only three

inverters can be con gured in a three-phase arrangement, but additional non-stacked

inverters—all of which must be Masters—can be plugged into any of the unused ports of

the HUB.

• These non-stacked inverters can only power loads that are independent of the three-phase

loads; additional AC load panels will be required.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Sin comentarios

Outback Power Systems HUB10 Manual de usuario Pagina 9