Outback Power Systems FLEXware 500 Manual de usuario descargar pdf (Pagina 13)

• Line up either the ACA or DCA on its respective side of the FX, starting at the top.

• To attach a DCA, line up its two screw holes with the upper and lower right DCC screw holes.

• When lined up, loosely install the upper screw to hold the DCA in place.

• Slide the DC chassis over snug against the DCA (the screw slots in each chassis are oval-shaped

to allow for movement) so the DCA lines up with the conduit adapter hole on the chassis.

• Install the plastic bushing from inside the chassis into the DCA (see Figure 11).

• After inserting the bushing into the top DCA, the remaining DCA will line up and the other

bushing installed.

• With all the DCA’s aligned with the DC chassis and the bushings installed, tighten the DC Chassis

screws against the FW-MP.

• The single screws holding each DCA in place can be removed later when the DCC’s are installed.

A single screw holds each DCA conduit adapter in place. Slide the DC chassis against each DCA

and line it up with the plastic bushing.

Figure 10: DCA in place

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sin comentarios

Outback Power Systems FLEXware 500 Manual de usuario Pagina 13