Outback Power Systems FLEXware 500 Manual de usuario descargar pdf (Pagina 14)

Plastic bushing,

DC side

Figure 11: DCA bushing

Note: The DCA will be held rmly in place when the DCC (FX cover) is secured at the end of the

installation.

To install an ACA:

• Follow the separate ACA instructions for mounting to the FX.

• Line each ACA up with its conduit hole in the AC chassis.

• When aligned, move the AC chassis snug against the ACAs after the ACA installations.

• Press a 1” plastic bushing from inside the AC chassis out to the ACA through each previously

removed knockout, sliding the AC chassis against the ACAs until snug.

• Install two M5 X 25mm screws (provided in ACA hardware kit) in each ACA and tighten securely.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Sin comentarios

Outback Power Systems FLEXware 500 Manual de usuario Pagina 14