Outback-power-systems FLEXware 500 Users Guide Manual de usuario

900-0002-01-00European Sales OfficeBarcelona, España(+34) 600-843-84519009 62nd Avenue NEArlington, WA USA(+1) 360-435-6030www.outbackpower.com

TMTM7After the FXs are installed, mount the AC chassis and the DC chassis in either order.Note: It is easier to remove the appropriate side knockouts

TMTM11Plastic bushing, DC sideFigure 11: DCA bushingNote: The DCA will be held rmly in place when the DCC (FX cover) is secured at the end of the ins

TMTM9Clear plastic AC coverAC Conduit PlateFigure 9: FX Series Inverter/ChargerDC Wiring Cover (DCC)Figure 8: AC and DC chassis mountedWith each chas

OutBack Power Systems FLEXware is a system of modular aluminum mounting hardware and installation components designed for convenient system installati

Requirements and WarningsThe OutBack FLEXware 500 enclosures (FW500-AC and FW500-DC) are listed by ETL as indoor enclosures to UL standard UL 508A Ind

TMWelcome to OutBack Power Systems’ FLEXwareFLEXware is a convenient all-aluminum power system oering simpler, code-compliant installation of OutBack

TM HUBFigure 1: Complete FLEXware 500 System installed (vertical installation is acceptable when mounting space is limited)Note: Although FLEXware 50

TMTM3Front ViewSide ViewFigure 2Knockouts and Dimensions11.4018.2712.06Figure 15: Wiring Diagram16

TMTM15Installing an OutBack HUBAn OutBack HUB allows the FX Series Inverter/Chargers, MX60 Charge Controllers, and MATE to communicate with each other

TMTM5Installation Tips• Never use less than the minimum recommended number and type of fasteners when installing the FLEXware Mounting Plates. •

TMTM13MX60 InstallationA FLEXware 500 System will normally have up to two MX Charge Controllers installed on the FW500-DC. The chassis accommodates bo