Outback-power-systems MATE2M System Controller and Display Installation Manual de usuario descargar pdf (Pagina 8)

2.2.4 The ‘INV’ Hot Key

The OutBack MATE2M includes an

INV “hot” key to allow direct control of the inverter from anywhere in the menu system.

The

INV key is located on the right side of the MATE2M LCD display. Pressing the INV key will take you to the INVERTER

CONTROL menu section as shown below.

A green LED indicator is located above the

INV key which flashes when the inverter is either in the search or power save

modes, and is on continuously when full AC output voltage is available from the inverter. When the inverter is turned off or

when the AC input source is being used, the green LED will not be illuminated.

When an OutBack HUB is employed, the

INVERTER CONTROL options effect all FX inverters on the HUB.

19009 62

Ave NE, Arlington WA 98223 USA

Page 8 Rev 1.00 03/31/04 Tel 360 435 6030 Fax 360 435 6019

INVERTER CONTROL

currently: ON

OFF SRCH ON OK

<OFF> Turns all the inverters connected to the MATE2M off

INV

<SRCH> Causes the inverter to begin operating in the search mode if the AC

load connected is smaller than allowed by the programming of the

search function.

<ON> Turns all the inverters connected to the MATE2M on

<OK> Returns to the point in the menu system where you entered the

INVERTER CONTROL screen

2.2.5 The ‘AC IN’ Hot Key

The OutBack MATE2M includes an AC IN “hot” key to allow direct control of the AC input from anywhere in the menu system.

The

AC IN key is located on the left side of the MATE2M LCD display.

Above the

AC IN key is a yellow LED indicator which flashes when an AC source is available but not connected and which is

on continuously when the AC source is connected and in use. If no AC source is connected the yellow LED indicator will

remain off.

AC INPUT CONTROLS

GEN AC AC

START INPUT AMPS OK

C IN

Pressing the <AC IN> key brings up the AC INPUT CONTROLS screen. This screen

allows the user to adjust common AC input settings and modes. When an OutBack

HUB is employed, the

AC INPUT CONTROLS only effects the Master FX connected to

PORT 1. The Master then echoes the command to all of its slaves.

<GEN START> Controls the MATE2M Advanced Generator Starting Mode. See

Section

5.0 MATE2M Advanced Generator Starting.

<AC INPUT> Sets the input mode to CORD or GEN.

<AC AMPS> Allows the user to adjust shore cord AC input amps.

Continued on next page

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 38 39

Comentarios a estos manuales

Sin comentarios

Outback-power-systems MATE2M System Controller and Display Installation Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Proveedores De Energía Outback-power-systems MATE2M System Controller and Display Installation