Outback-power-systems FLEXnet DC Users Guide Manual de usuario descargar pdf (Pagina 25)

Shunt 1 is, by default, enabled or active when the FX is

powered up. Pressing the <DIS> soft key disables the  rst

shunt. Pressing the <DOWN> soft key leads to the shunt 2

mode and shunt 3 mode screens. These shunts are disabled

at power-up and are enabled by pressing the <EN> soft key.

When the setup for all shunts has been completed, press the

<DOWN> soft key for the next screen.

ADV/DC/SHUNT 1 ---------------

shunt 1 mode

DOWN EN DIS TOP

Press the <BAT> soft key.

ADV/DC/PAGE 1----------------

choose category

ADV BAT SHUNT PG2

ADV/DC/SHUNT-----------------

shunt setup complete

TOP ADV MAIN

Use the battery capacity screen to set the battery bank

capacity using either the <INC> or <DEC> soft key. When

 nished, press the <TOP> soft key.

ADV/DC/BAT-------------------

battery capacity

amp hours

TOP INC DEC ADV

Press the <SHUNT> soft key.

ADV/DC/PAGE 1----------------

choose category

ADV BAT SHUNT PG2

Pressing the <DOWN> soft key

changes the shunt being enabled

or disabled.

Press the <ADV> soft key.

Press the <DC> soft key.

ADV--------------------------------

choose device:

FX CC DC MATE

Press the <PG2> soft key.

ADV/DC/PAGE 1----------------

choose category

ADV BAT SHUNT PG2

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 33 34

Sin comentarios

Outback-power-systems FLEXnet DC Users Guide Manual de usuario Pagina 25