Outback-power-systems FLEXware 250 - Users Guide Manual de usuario descargar pdf (Pagina 11)

Installing the FLEXware 250

With the FX secured to a surface (see FX Series Inverter/Charger Installation Manual for details),

the FLEXware 250 installs on either the DC or the AC side of the FX.

To install the FLEXware 250:

• Remove the cover plate screws and cover plate.

• Verify which knockouts will be removed for the installation and remove those knockouts.

• Remove only the two M5 X 12mm screws that secure the FX’s upper and lower casing

halves on whichever side (AC or DC) you rst install the FLEXware 250.

• Insert the unthreaded standos into the holes on the FX and then insert two M5 X 25mm

screws, included with the FLEXware 250, into the standos and tighten.

• After all wiring has been completed, install the DCC and securing with four M5 X 12mm

screws (included with the DCC).

• Install each FLEXware 250 top cover plate and secure the #10 X 3/8” sheet metal screws.

For AC wiring instructions for the FLEXware 250, please see the schematics in the individual

AC Input/Output/Bypass Assembly (IOB) kits.

Figure 8: FLEXware 250 Dimensions

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Outback-power-systems FLEXware 250 - Users Guide Manual de usuario Pagina 11