Outback-power-systems GS4048A Operators Manual Manual de usuario descargar pdf (Pagina 14)

Commissioning

12 900-0161-01-00 Rev A

Firmware Updates

IMPORTANT:

All inverters will shut down during firmware updates. If loads need to be run

while updating the firmware, bypass the inverter with a maintenance bypass

switch. Communication cables must remain connected and DC power must

remain on. Interrupted communication will cause the update to fail and the

inverter(s) may not work afterward. Inverters automatically update one at a time

beginning with Port 1. Each requires about 5 minutes.

Updates to the Radian’s internal programming are periodically available at the OutBack website

www.outbackpower.com. If multiple inverters are used in a system, all units must be upgraded at the

same time. All units must be upgraded to the same firmware revision.

If multiple stacked Radian inverters are used with different firmware revisions, any inverter with a

revision different from the master will not function. (See the stacking section on page 35.) The MATE3

will display the following message:

An inverter firmware mismatch has been detected. Inverters X, Y, Z

are disabled. Visit

www.outbackpower.com for current inverter firmware.

NOTES:

The port designations for the mismatched inverters are listed here.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Sin comentarios

Outback-power-systems GS4048A Operators Manual Manual de usuario Pagina 14