Outback-power-systems VFX Series International Programming Manual Manual de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 56
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
36
PRESS <INC> UNTIL 141,
THEN PRESS ENTER.
STACKING SYSTEM EXAMPLES
OutBack Parallel Stacking
Four FXs in a single system are referred to as a Quad Stack.
The FX installed at the bottom of the stack is plugged into Port 1 of the HUB.
The second, third, and fourth FXs are plugged into Ports 2, 3, and 4 respectively.
ADV/PASSWORD-------------
enter the password
132
ENTER INC DEC EXIT
ADV/SETTINGS/WARNING
changes made could adversely
a ect system performance
MAIN----------------------
8:25:04A
SUM STATUS SETUP ADV
ADV/FX/PG2-----------------
choose category:
PG1 GRID GEN PG3
ADV/FX/PAGE 1--------------
choose category:
ADV INV CHGR PG2
ADV----------------------------
choose a device:
FX CC DC MATE
ADV/FX/STACK-----------P02
stack 1-2ph Master
phase
DOWN INC DEC PORT
ADV/FX/STACK---------P01
stack 1-2ph Master
phase
DOWN INC DEC PORT
ADV/FX/PAGE3---------------
choose category:
PG2 AUX STACK PG4
ADV/FX/STACK---------P04
stack OB Slave L1
phase
DOWN INC DEC PORT
ADV/FX/STACK----------P03
stack OB Slave L1
phase
DOWN INC DEC PORT
Push the <PORT> soft key until
Port 01 appears.
Press the <PORT> soft key until
Port 02 appears. Press the <INC>
soft key twice until the stack
phase ob slave L1 screen appears.
Press the <PORT> soft key until
Port 03 appears. Press the <INC>
soft key twice until the stack phase
ob slave L1 screen appears.
Press the <PORT> soft key until
Port 04 appears. Press the <INC>
soft key twice until the stack phase
ob slave L1 screen appears.
At completion, each Slave FX in Ports 2, 3, and 4 will be in parallel with the Master in Port 01. Addi-
tional Slaves can also be programmed as OB Slave L1 following the instructions above. All the Slave FXs
connected to Ports 2, 3, and 4 are now in parallel with the Master in Port 01. Remain in this screen. The
next step is to rank the Slaves in relation to the Master.
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Comentarios a estos manuales

Sin comentarios