Outback-power-systems MATE2 System Controller and Display Installation a Manual de usuario descargar pdf (Pagina 11)

• InstallallotherOutBackcomponentsrst.

• RuntheCAT5cablefromthesource(HUB,FXorChargeController)totheMATE’s

location.ConnecttheCAT5cabletothesourcebutnottotheMATEjustyet.

• IfconnectingacomputertotheMATEorMATE2,runaserialcablefromthecomputerto

theMATE’slocation,butdonotconnectthecableatthistime.

• UnsnaptheMATE’sbackplateandndthefourscrewholes.IfaMATE2versionisused,

the back cover need not be removed.

• eMATEandMATE2aredesignedforeasywallmountingusingappropriatefasteners

(mollybolts,screws,etc.).

• PowerupeveryOutBackdeviceconnecteddirectlyorindirectly(throughtheHUB)tothe

MATEandthenconnecttheCAT5cabletothejackand,ifused,thecomputerserialcable

totheRS-232port,onthebackMATEorMATE2.

• IfinstallingtheMATE,snaptheMATEontothebackplateandpushanyexcesscableback

intothewall.IfinstallingtheMATE2version,secureitsfourcornerstothewall.

DC  ‡ AC ……………….0.0 kW

AC L oad …. ……………………..

Buying ………………………….

Battery …………….…14.4V

MATE2 Dimensions

15.875 cm (6 1/4”)

11.43 cm (4 ½”)

8.89 cm (3 ½” ) between screw holes

To Install the MATE:

12.7 cm (5” ) between screw holes

A C IN

I NV

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 131 132

Sin comentarios

Outback-power-systems MATE2 System Controller and Display Installation a Manual de usuario Pagina 11