Outback-power-systems MATE2 System Controller and Display Installation a Manual de usuario descargar pdf (Pagina 66)

HBX-Drop Grid Set Point

HBX-Drop Grid Delay

ADV/MATE/HBX---------------------

hbx-drop 26.0 vdc

grid setpoint

DOWN UP INC DEC

ADV/MATE/HBX---------------------

hbx-drop 01.0 hrs

grid delay

DOWN UP INC DEC

issetpointshowsthevoltage—26.0VDC

isthedefaultfora24Vsystem—atwhichthe

FXwillDROPitsACinputsource.ebattery

voltage must remain above this voltage for the

amountoftimesetbyHBX-DROPGRIDDELAY

(nextscreen)foraDROPtobeissued.Pressthe

<DOWN> so key to proceed.

issetpointistheamountoftime—01.0hrsin

thiscase—batteryvoltagemustremainabovethe

HBX-DROPGRIDSETPOINT(seeprevious

screen)beforeaDROPcommandissent.Itcan

rangefrom00.1hrsto24.0hrsin0.1hourincre-

ments. ese increments are adjusted using the

<INC> and <DEC> so keys. Press the <DOWN>

so key to proceed.

Withthisscreen,HBXModecanbeenabledor

disabled. Pressing <CHANGE> allows you to

changethecurrentmodeinthenextscreen.

AC Input Control

ADV/MATE/HBX---------------------

ac input USE

control

DOWN UP CHANGE

NOTE:BeforeenablingHBXMode,makesurethe

FXisinDROPmodebypressingthe<DROP>

sokey.escreenwillindicateDROPmode,

allowingtheMATEtoresettheHBXvalues.

ADV/MATE/HBX---------------------

ac input USE

control

DROP USE HBX DONE

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 131 132

Sin comentarios

Outback-power-systems MATE2 System Controller and Display Installation a Manual de usuario Pagina 66